Performance Reports; Mobile Applications; Notifications (Service And Alert Codes); Alert Code Types - Lennox 19V30 Installation And Setup Manual

buttons representing OPEN and SECURE wireless networks, along with
button for adding a network.
2. Select the access point that has already been established and connected.
When selecting the info icon, a screen will appear which will display an
option to forget the network and IP address assigned to the thermostat
by your router, sub-net mask, router, DNS and RSSI. If the RSSI signal
strength is anywhere between -9 to -69, then the signal strength is
sufficient. If outside this range, then either relocate the router closer to the
thermostat, add a repeater, or move the smart hub. Adjusting antenna on
router and/or smart hub may resolve the issue.
Home Network . . . . . . . . . . . . . . . . . . . . . . . .
forget this network
IP address . . . . . . . . . . . . . . .
subnet mask . . . . . . . . . . . .
router
DNS
R S I S . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 22. Verifying Signal Strength

Performance Reports

Performance reports are only available through either the consumer or dealer
web portals.
• Homeowner access is available at www.myiComfort.com.
• Dealer access is available through the Dealer Dashboard at
www.LennoxPros.com.
More information concerning Performance Reports is available in the user
guide.

Mobile Applications

iComfort Thermostat App (Homeowner)
• The free iComfort Thermostat app is available for use on iPhone
Android™ devices.
• Control cooling/heating temperatures, fan operation, set programs and set
Away mode for multiple locations.
i
192.168.1.4
255.255.255.0
4 - 0
, iPad
®
• Controls individual zone settings if system is equipped with the optional
iHarmony Zoning System.
®
• Controls PureAir S Air Purification System
• Controls fresh air dampers and ERV/HRV when connected to ACC1 and
ACC2 terminals.
iComfort Mobile Setup App (Installer)
• The free iComfort Setup app allows the installer to commission and service
the system on any iPhone
• Remotely turn the system on and off during setup.
Apple, the Apple logo, iPhone and iPad are trademarks of Apple Inc. registered in the US and
other countries.
Android is a trademark of Google Inc. Use of this trademark is subject to Google permission.

Notifications (Service and Alert Codes)

These screens provide information on active notifications and previously
cleared notifications. When selecting either a cleared or active notification a
brief description and alert code will be displayed. Notifications are categorized
by system, indoor unit (air handler or furnace), outdoor unit (air conditioner or
heat pump), zoning control (if installed) and thermostat.

Alert Code Types

To expand a specification notification to access a more detail description of the
alert code, press the down arrow to expand the description.
• Service Urgent alerts are displayed on Home (user) screen under the
homeowner and installer alert buttons. Service Urgent means that a service
call is needed to get the system running.
• Service Soon / Service Urgent means that the system will likely recover
on its own and no interaction is necessary. Typically, either after a specific
timer period or a specific number of instances, some Service Soon alerts
will escalate to Service Urgent.
• Service Soon alerts are found only in under the installer alert button.
• Information Only-Dealer is information only and helps Lennox interpret test
results and understand complicated behaviors. Information Only are not
reported to homeowner or dealer.
NOTE: Communication System: When communication controls are
and
®
operating in a communication system, all jumpers and links setting
on the controls are ignored. Jumpers and links setting are treated as
defaults and would only be active if the system was configured as a
non-communicating system.
53
, iPad and Android™ device.
® ®