Installer System Setup - Lennox iComfort S30 Installation And Setup Manual

The following procedures are written for the installer setup using the HD wall
display.
When power is first applied to the system all communicating devices attached to
the system (air handler or furnace, outdoor unit or zoning control) will automatically
be configured using optimal factory default settings based on system type,
capacity and other configuration considerations.
BOOTUP SCREEN
When power is applied to the system, the HD display or sometimes referred to as
thermostat will display a welcome screen. For the dealer mobile application, refer
to figure 13 for establishing a wireless connection between the mobile application
and Smart Hub
If there is an issue with communication between any component attached to the
iComfort® S30, a critical alert message will appear on the screen. The alert
message will provide detail information concerning the possible cause. Once the
issue is corrected and power is restored to the system the first screen in the initial
setup sequence will appear.
your thermostat cannot connect to the
Please make sure the equipment is wired
correctly and reboot it
for assistance please contact
NOTE: If a critical low battery screen is displayed, the system will automatically
start charging the HD display internal battery. On the screen the word "charging"

INSTALLER SYSTEM SETUP

critical
equipment
1-800-0-Lennox
try again
will appear. Once "charging" disappears (typically 3 to 10 minutes) then the display
will automatically start-up.
DEALER INFORMATION
The first screen in the installer system setup sequence is the dealer information
screen. Here either the dealer ID and/or phone number can be added. When the
system is connected to the Internet, the remaining information is automatically
populated by the Lennox server. All information can be entered manually if desired
however.
NOTE: Not all information for this screen is viewable on a single screen. Use a
finger to swipe up to access the remaining information on the screen.
Information Required: Dealer ID and / or dealer phone number. Information that
can be manually entered is name, email website, dealer address which includes
address 1, address 2, city state and zip code. Once completed press continue.
Warning Screen: If either the dealer ID or phone number is NOT provided, a
warning screen will appear. The warning screen will provide information on the
limitation imposed on the system if this information is not provided. Press no to
return to the previous screen to complete the information requested or press yes
to continue.
GENERAL INFORMATION
IMPORTANT: IF THE FOLLOWING INFORMATION IS NOT COMPLETED THE
®
ICOMFORT S30 WILL NOT BE ASSOCIATED TO THE DEALER IN DAVENET.
On this screen general information needs to be verified or changed. Press any item
to change its contents. A pop-up screen will appear that will allow the information to
be added or changed.
Information Required:
1. Select desired language (ENGLISH, FRANÇAIS, ESPAÑOL).
2. Select country / region.
3. Select time and date which includes time, date, time zone, daylight savings
time (ON/OFF) and temperature unit (Fahrenheit or Celsius).
Once completed press continue.
HOME ADDRESS
On this screen the homeowner address needs to be verified or changed. Press any
line item to change its contents. Information to be added is address 1, address 2,
state, city and zip code.
Complete the requested information and press the continue button.
EQUIPMENT FOUND
This screen will display any communicating equipment the system has detected
(air handler, outdoor unit, smart hub and zoning control during initial powering up
of the system.
14