Connecting Mobile Application To Smart Hub; Connecting App To Smart-Hub - Lennox iComfort S30 Installation And Setup Manual

MOBILE APPLICATION DIRECT CONNECTION TO ICOMFORT
CONNECTING MOBILE APP TO ICOMFORT
1. Press the center Lennox button once on the Smart-Hub. After pressing, center green ring LED starts blinking.
2. Launch Lennox Service Mobile Application if not yet running.
3. Select DIRECT-xy-ABCD SSID* and connect to it. (*example)
4. Connect and enter "PIN". The character ABCD in SSID is the PIN.
5. After connecting to the mobile device the center green ring LED stays solid green.
6. Proceed to the Installer System Setup section to continue.
RESTARTING SMART HUB
RESETTING SMART HUB - Pressing the center Lennox button for more than 5 seconds will restart the SMART HUB.
ICOMFORT SMART HUB NORMAL CONDITION
Figure 13. Connecting Mobile Application to iComfort
®
S30 SMART HUB
®
S30 SMART HUB USING SMART-HUB WI-FI*
* SMART-HUB WI-FI is a self-contained Wi-Fi network (peer-to-peer) hosted by the SMART-HUB and totally
independent of any other local network. SMART-HUB WI-FI is used to connect multiple SMART-HUBs de­
vices and mobile devices running running either the Consumer or Dealer Mobile applications. Mobile devices
will require the SMART-HUB SSID and PIN number to connect. Both SSID and pin number are located on the
SMART-HUB device. If multiple SMART-HUBS are installed, access to only one is required to control the en­
tire system.
LENNOX CENTER
BUTTON (LED RING)
®
S30 Smart Hub using Smart Hub Wi-FI
13