Add Guest Port Dialog - Polycom RealPresence DMA 7000 System Operation Manual

Field
Require mutual
authentication (validation
of client certificates)
Unauthorized ports
Unauthorized prefixes
See also:
Local Cluster Configuration
Local Cluster Configuration Procedures

Add Guest Port Dialog

The Add Guest Port dialog appears when you click the Add button next to the Unauthorized ports list in
the SIP Settings section of the Signaling Settings page. It lets you add a port to the list of ports used for
"unauthorized" or "guest" calls.
The following table describes the fields in the Add Guest Port dialog.
Field
Port
Transport
Polycom, Inc.
Description
Check the box to enable mutual TLS, requiring each caller to present a valid
certificate.
Note: This setting is enabled and locked if Unlock SIP Settings mutual
authentication option on the Signaling Settings page option is unchecked
on the Security Settings page. See
Lists the ports used by your SBC(s) for untrusted calls, showing the transport
type for each and, for TLS, whether a certificate is required. The
Authentication column indicates whether calls to that port are passed without
challenge, challenged for authentication credentials, or blocked.
Click Add to add a port to the list (see
edit the selected entry (see
Lists the prefixes used by your SBC(s) for untrusted calls. The Strip Prefix
column indicates whether the RealPresence DMA system should immediately
strip the prefix. The Authentication column indicates whether calls to that
port are passed without challenge, challenged for authentication credentials,
or blocked.
Click Add to add a prefix to the list (see
to edit the selected entry (see
Description
The SIP signaling port number for this entry.
This is the port number that an SBC is configured to use for untrusted calls to
the RealPresence DMA system via the transport specified below.
To use this guest port for unencrypted SIP connections, select either TCP or
UDP/TCP from the list. To use this port for encrypted SIP connections, select
TLS.
Local Cluster Configuration
Security Settings.
Add Guest Port
Edit Guest Port Dialog) or Delete to delete it.
Add Guest Prefix
Edit Guest Prefix Dialog) or Delete to delete it.
Dialog). Click Edit to
Dialog). Click Edit
74