Table of Contents
Advertisement
Field
Content settings
Content rate
AS SIP content
Multiple content
resolutions
Transcode to
Content protocol
Content resolution
H.264 high profile
Send content to legacy
endpoints (MPM+ or
newer)
RMX Video Settings
Presentation mode
Polycom, Inc.
Description
The transmission mode for the Content channel:
•
Graphics — lowest bit rate for basic graphics
•
High-resolution graphics — higher bit rate for better graphics resolution
•
Live video — the Content channel is used for live video
•
Customized content rate — allows you to specify a Content rate
A higher bit rate for the Content channel reduces the bit rate for the People
channel.
Bit rate of the content channel. Enabled when the Customized content rate
content setting is selected.
Enables the sharing of content using the AS-SIP protocol security features.
Enables content sharing over multiple video streams. When selected, you can
choose which protocols to use for each stream with the Transcode to setting.
Note: Enabled only when:
Conference mode is set to AVC only.
TIP compatibility is set to either None or Video Only.
Enables you to choose which protocols to use for each stream of content.
Enabled when the Multiple content resolutions check box is selected.
Note: The H.264 protocol check box is always selected.
Content channel protocol options:
•
Use H.263.
•
Use H.264 if available, otherwise use H.263.
•
Use H.264 cascade and SVC optimized.
•
Use H.264 HD.
Specifies the resolution of the content channel for the conference and
cascade link.
Available only when Content protocol is set to H.264 cascade and SVC
optimized.
Enables the H.264 High Profile set of capabilities for the content channel,
which enables additional compression efficiency and allows for higher
resolutions to use the same bandwidth.
Enables endpoints that don't support H.239 to receive the Content channel
over the video (People) channel.
Available only on MCUs with MPM+ and MPMx cards. Not available if Video
switching or Same layout is selected, or if Telepresence mode is Yes.
Enables a conference to change to lecture mode when the current speaker
speaks for 30 seconds. When another participant starts talking, it returns to
the previous video layout.
Not available if Video switching or Same layout is selected, or if
Telepresence mode is Yes.
Conference Manager Configuration
199
Advertisement
Table of Contents
