Table of Contents
Advertisement
Field
Default max total participants
Default conference template
Default conference room territory
Default MCU pool order
MCU Selection
Minimum generated room ID
Maximum generated room ID
Default resource priority
namespace
Default resource priority value
Default Conference Duration
Presence Publishing
Polycom, Inc.
Description
Specifies the maximum conference size assigned to a conference room if a
larger or smaller maximum size isn't specified for it.
Automatic (the default setting) uses the largest conference size supported by
the MCU (or by all available MCUs if cascading is enabled) as the default
maximum.
Default template used by the system. See
The territory assigned to a user's conference room if it isn't specified at the
user or conference room level.
A conference room's territory assignment determines which RealPresence
DMA cluster hosts the conference (the primary cluster for the territory, or its
backup cluster if necessary). Up to three territories in a superclustered system
can host conference rooms.
Default MCU pool order used by the system. See
The method for the RealPresence DMA system to use when it selects MCUs
from MCU pools:
Prefer MCU in first MCU pool ensures that the DMA system will always route
the call to the first available MCU in the first MCU pool. If no MCU is available,
the second MCU pool will be searched for an available MCU, and so on.
Prefer MCU in first caller's site will match the MCU chosen for the call with
the site that the first caller's endpoint belongs to.
Specify the minimum and maximum values for auto-generated room IDs
created for custom conference rooms. Values may be up to six digits long, and
the minimum must be less than the maximum.
The six-digit limit applies only to generated IDs for custom conference rooms.
In an Assured Services SIP (AS-SIP) environment, a Local Session Controller
(LSC) can provide priority-based precedence and preemption services to
ensure that the most important calls get through. If your organization has
implemented such a resource prioritization mechanism, set this to the
namespace being used for resource priority values. If the namespace being
used isn't listed, select Custom and enter the name in the box to the right of
the list.
If your organization has implemented a resource prioritization mechanism, set
this to the default priority value assigned to a conference if the specific
conference room (VMR) doesn't have a higher value. If using a custom
namespace, enter the value in the box to the right of the list.
The string namespace:value is used in the SIP Resource-Priority header of
outbound calls from conference rooms (VMRs).
Default maximum duration of a conference (in hours and minutes) or
Unlimited (the maximum in this case depends on the MCU).
This section allows you to configure Polycom conference contact presence
options.
Conference Manager Configuration
Conference
Templates.
MCU Pool
Orders.
184
Advertisement
Table of Contents
