Add Outbound Registration Dialog - Polycom RealPresence DMA 7000 System Operation Manual

Add Outbound Registration Dialog

Some external SIP peers require peers to register with them as an endpoint does, using a REGISTER
message (also known as pilot registration). The Add Outbound Registration dialog lets you add outbound
registration configurations that the system can use to register with the SIP peer that you're adding or editing,
following the rules specified in RFC 3261.
The following table describes the fields in the Add Outbound Registration dialog.
Field
Enabled
Address of record
Territory to perform registration
Contact address format
User name
Password
Confirm password
Request-URI
Other headers
See also:
External SIP Peer
Add External SIP Peer Dialog
Edit External SIP Peer Dialog
Polycom, Inc.
Description
Clearing this check box lets you stop using this registration without deleting
the registration information.
The AOR with which the system registers (see registration rules in
RFC 3261), such as:
sip:1000@dma.polycom.com
Responsibility for registering must be assigned to a territory, thus making the
primary or backup RealPresence DMA cluster for the territory responsible,
depending on which is active.
Select IP or DNS to specify that the contact header should use the virtual IP
address or virtual DNS name of the cluster currently managing the territory. If
the territory responsibility switches to the other cluster, it re-sends the
registration using its IP address or DNS name.
Select Free Form to specify that the contact header should use the FQDN
you enter. The external peer must be able to resolve this FQDN.
The user name to use for the authentication credentials if the external peer
challenges the registration request.
Note: The authentication credentials specified here are specific to this SIP
peer and are not tied to any other authentication configuration values.
The password to use for the authentication credentials if the external peer
challenges the registration request.
The Request-URI to include when registering with this SIP peer, specified
using the variables (#delimited) defined in
Additional headers to include when registering with this SIP peer.
Click Add to add a header. In the Add Header dialog, specify the header
name and value(s), using the variables (#delimited) defined in
Template Variables.
Click Edit or Delete to edit or delete the selected header.
Device Management
Free Form Template Variables.
Free Form
119