Led Indications - Planet Networking & Communication WGSW-24040 User Manual

Reset Button Pressed and Released
< 5 sec: System reboot
> 5 sec: Factory Default
■ Console Port
The console port is a DB9, RS-232 male serial port connector. It is an interface for connecting a terminal directly. Through
the console port, it provides rich diagnostic information includes IP Address setting, factory reset, port management, link
status and system setting. Users can use the attached RS-232 cable in the package and connect to the console port on the
device. After the connection, users an run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix, Winterm
and so on) to enter the startup screen of the device.

2.1.2 LED Indications

The front panel LEDs indicates instant status of port links, data activity and system power; helps monitor and troubleshoot when
needed. Figure 2-3 shows the LED indications of these Managed Switches.
WGSW-24040 / 24040R LED indication
■ System
LED Color
PWR Green
■ Per 10/100/1000Mbps Port
LED Color
1000
Green
LNK/ACT
Function
Reboot the Managed Switch
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
。
。
。
。
。
Figure 2-3 WGSW-24040 / 24040R LED for Front Panel
Lights to indicate that the Switch has power.
Lights to indicate the port is running in 1000Mbps speed and successfully established.
Blink: indicate that the switch is actively sending or receiving data over that port.
User's Manual of WGSW-24040 / WGSW-24040R
Default Username: admin
Default Password: admin
Default IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Default Gateway: 192.168.0.254
Function
Function
31