Removing The Rear Shock Absorber Assemblies And Swingarm - Yamaha YBR125ED 2005 Service Manual

REAR SHOCK ABSORBER ASSEMBLIES
1
1
È
É
AND SWINGARM
EAS00691/EAS00703
REMOVING THE REAR SHOCK ABSORBER
ASSEMBLIES AND SWINGARM
1. Stand the vehicle on a level surface.
WARNING
_
Securely support the vehicle so that there
is no danger of it falling over.
NOTE:
_
Place the vehicle on a suitable stand so that
the rear wheel is elevated.
2. Remove:
• rear wheel
Refer to "REAR WHEEL, BRAKE SHOE
PLATE, AND REAR WHEEL SPROCKET".
3. Remove:
• rear shock absorber assemblies 1
4. Measure:
• swingarm side play
• swingarm vertical movement
M MMM M MMM M M MMM
a. Measure the tightening torque of the pivot
shaft nut.
Pivot shaft nut
59 Nm (5.9 m · kg, 43 ft · lb)
b. Measure the swingarm side play È by mov-
ing the swingarm from side to side.
c. If the swingarm side play is out of specifica-
tion, check the spacers, bearings, washers,
and dust covers.
Swingarm side play (at the end of
the swingarm)
1.0 mm (0.04 in)
d. Check the swingarm vertical movement É
by moving the swingarm up and down.
If swingarm vertical movement is not
smooth or if there is binding, check the
spacers, bearings, washers, and dust cov-
ers.
L LLL L LLL L L LLL
4 - 67
CHAS
M M MMM M M MMM M
L L LLL L L LLL L
M MMM M MMM
L LLL L LLL