Yamaha YBR125ED 2005 Service Manual page 42

É Make sure that the headlight assembly lead is
routed through the protective covering.
Ê Connect the main switch lead, right handlebar
switch lead, left handlebar switch lead, meter
assembly lead, clutch switch lead, front brake
light switch lead, front turn signal light lead
(right), and front turn signal light lead (left), and
then cover the leads with the protective cover-
ing, and attach the protective covering.
Ë Pass the clutch cable, left handlebar switch lead,
and clutch switch lead through the guide.
1 2
B
A
0
3 4
È
5
8
9
Ê É
1
2
Ì
B
Ð
CABLE ROUTING
Ì Pass the throttle cable, front brake hose, front
brake light switch lead, and right handlebar
switch lead through the guide.
Í Fasten the right handlebar switch lead and front
brake light switch lead with the plastic band.
Î Fasten the left handlebar switch lead and clutch
switch lead with the plastic band.
Ï Pass the speedometer cable through the guide.
Ð Fasten the wire harness with the plastic locking
tie to the bracket. Cut off the excess end of the
plastic locking tie.
2
Ì
D
1
6
7
Ë
4
6
C
A 4
2 - 26
SPEC
B
Í
Î
Ë
6
5
Ï
9
E
F