Yamaha YBR125ED 2005 Service Manual page 98

CHECKING AND CHARGING THE BATTERY
2
1
7. Check:
• battery breather hose and battery vent
Obstruction → Clean.
Damage → Replace.
8. Connect:
• battery breather hose
9. Install:
• battery
• battery band
CAUTION:
_
• When checking the battery, make sure the
battery breather hose is properly installed
and routed correctly. If the battery
breather hose is positioned so as to allow
electrolyte or hydrogen gas from the bat-
tery to contact the frame, the vehicle and
its finish may be damaged.
• Make sure the battery breather hose is
properly routed away from the drive chain
and from below the swingarm. Refer to
"CABLE ROUTING".
10.Check:
• battery terminals
Dirt → Clean with a wire brush.
Loose connection → Connect properly.
11.Connect:
• battery leads
(to the battery terminals)
CAUTION:
_
First, connect the positive battery lead 1,
and then the negative battery lead 2.
12.Lubricate:
• battery terminals
Recommended lubricant
Dielectric grease
13.Install:
• left side cover
Refer to "SIDE COVERS, SEAT AND FUEL
TANK".
3 - 45
CHK
ADJ