Removing The Rear Shock Absorber Assemblies; Checking The Rear Shock Absorber Assembly; Installing The Rear Shock Absorber Assemblies - Yamaha PW50W 2007 Service Manual

REAR SHOCK ABSORBER ASSEMBLY AND SWINGARM
2
1
1
2
4-32
REMOVING THE REAR SHOCK
ABSORBER ASSEMBLIES
1. Stand the vehicle on a level surface.
w
Securely support the vehicle so that there
is no danger of it falling over.
NOTE:
Place the vehicle on a suitable stand so that
the rear wheel is elevated.
2. Remove:
9 Rear
shock absorber
(lower) 1
9 Rear
shock absorber
(upper) 2
9 Rear shock absorber assembly
CHECKING THE REAR SHOCK ABSORBER
ASSEMBLY
1. Check:
9 Rear shock absorber rod
(rear shock absorber assembly)
Damage/wear → Replace.
9 Rear shock absorber
Oil leaks → Replace the rear shock
absorber assembly
9 Rear shock absorber spring
Damage/wear → Replace.
9 Bushing
Damage/wear → Replace.
9 Bolt
Bend/damage/wear → Replace.
INSTALLING THE REAR SHOCK
ABSORBER ASSEMBLIES
1. Install:
9 Rear shock absorber assembly
9 Rear shock absorber bolt (upper) 1
9 Rear shock absorber bolt (lower) 2
2. Tighten:
9 Rear shock absorber bolt (upper)
9 Rear shock absorber bolt (lower)
CHAS
assembly bolt
assembly bolt
11 Nm (1.1 m·kg, 8.0 ft·lb)
23 Nm (2.3 m·kg, 17 ft·lb)