Removing The Rear Shock Absorber Assemblies; Checking The Rear Shock Absorber Assembly; Installing The Rear Shock Absorber Assembly; Removing The Seat Lock Cable - Yamaha CYGNUS RAY ZR 2022 Supplementary Service Manual

REAR SHOCK ABSORBER ASSEMBLY
REMOVING THE REAR SHOCK ABSORBER
ASSEMBLIES
1. Stand the vehicle on a level surface.
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
TIP
Place the vehicle on the suitable stand so that
the rear wheel is elevated.
1. Remove:
• Rear side cover assembly
Refer to "GENERAL CHASSIS" on page 4-6.
CHECKING THE REAR SHOCK ABSORBER
ASSEMBLY
1. Check:
• Rear shock absorber rod
Bends/damage  Replace the rear shock
absorber assembly.
• Rear shock absorber
Oil leaks  Replace the rear shock absorber
assembly.
• Spring
Damage/wear  Replace the rear shock ab-
sorber assembly.
• Bushings
Damage/wear  Replace.
• Bolts
Bends/damage/wear  Replace.
EAS06970
INSTALLING THE REAR SHOCK ABSORBER
ASSEMBLY
1. Install: (Temporary)
• Upper rear shock absorber bolt and nut "1"
• Lower rear shock absorber bolt "2"
TIP
Install the upper rear shock absorber bolt and
nut "3" for rear side bracket hole.
2. Set the centerstand to lift the rear wheel.
3. Tighten:
• Rear shock absorber lower bolt
Rear shock absorber lower bolt
25 N·m (2.5 kgf·m, 18 lb·ft)
4. Remove the rear shock absorber upper bolt
and move it to front side bracket hole.
5. Tighten:
• Rear shock absorber upper bolt and nut
Rear shock absorber upper bolt
25 N·m (2.5 kgf·m, 18 lb·ft)
6. Install:
• Rear side cover assembly
Refer to "GENERAL CHASSIS" on page 4-6.

REMOVING THE SEAT LOCK CABLE

1. Place the vehicle on a centerstand.
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
1. Remove:
• Rear side cover assembly
Refer "GENERAL CHASSIS" on page 4-6.
• Front side cover assembly (right)
Refer "GENERAL CHASSIS" on page 4-8.
2. Unhook the seat lock cable from bracket and
then remove the seat lock cable end "1".
4-24
CHAS
3
1