Installing The Rear Shock Absorber Assemblies And Swingarm - Yamaha YBR125ED 2005 Service Manual

REAR SHOCK ABSORBER ASSEMBLIES
AND SWINGARM
NOTE:
If adding an even number of shims, add the
same number to both the left and right sides of
the swingarm. If adding an odd number of
shims, the left side of the swingarm should
have one more shim than the right side.
Part number
5VL-F2127-00
d. Install all of the removed parts.
L LLL L LLL L L LLL
EAS00711/EAS00699
INSTALLING THE REAR SHOCK
ABSORBER ASSEMBLIES AND
SWINGARM
1. Lubricate:
• pivot shaft
• bushings
• oil seals
Recommended lubricant
Lithium-soap-based grease
2. Install:
• footrest bracket lower bolts (temporarily)
• swingarm
• pivot shaft
• pivot shaft nut (temporarily)
3. Tighten:
• pivot shaft nut
• footrest bracket lower bolts
4. Install:
• rear shock absorber assembly upper nuts
• rear shock absorber assembly lower nuts
5. Adjust:
• drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" in chapter 3.
Drive chain slack
20 ~ 30 mm (0.79 ~ 1.18 in)
4 - 70
CHAS
Shim size
Thickness
0.3 mm (0.012 in)
L L LLL L L LLL L
59 Nm (5.9 m · kg, 43 ft · lb)
26 Nm (2.6 m · kg, 19 ft · lb)
40 Nm (4.0 m · kg, 29 ft · lb)
32 Nm (3.2 m · kg, 23 ft · lb)
L LLL L LLL