Yamaha YBR125ED 2005 Service Manual page 137

FRONT BRAKE
4. Install:
• brake pad springs
• brake pad shim
• brake pads
• brake caliper
Refer to
BRAKE PADS".
5. Fill:
• brake master cylinder reservoir
(with the specified amount of the recom-
mended brake fluid)
Recommended brake fluid
DOT 3 or 4
WARNING
_
• Use only the designated brake fluid.
Other brake fluids may cause the rubber
seals to deteriorate, causing leakage and
poor brake performance.
• Refill with the same type of brake fluid
that is already in the system. Mixing
brake fluids may result in a harmful
chemical reaction, leading to poor brake
performance.
• When refilling, be careful that water does
not enter the brake master cylinder reser-
voir. Water will significantly lower the
boiling point of the brake fluid and could
cause vapor lock.
CAUTION:
_
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean
up any spilt brake fluid immediately.
6. Bleed:
• brake system
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" in chapter 3.
4 - 34
CHAS
23 Nm (2.3 m · kg, 17 ft · lb)
"REPLACING THE FRONT