Yamaha YBR125ED 2005 Service Manual page 153

3
a
2
b
5. Install:
• left handlebar switch 1
1
NOTE:
_
Align the projection a on the left handlebar
a
switch with the hole b in the handlebar.
6. Install:
b
• clutch cable
NOTE:
_
Lubricate the end of the clutch cable with a thin
coat of lithium-soap-based grease.
7. Install:
• brake master cylinder
• brake master cylinder holder
8. Install:
• throttle grip 1
• throttle cable 2
1
• right handlebar switch 3
• grip end
NOTE:
_
• Lubricate the end of the throttle cable and
• Route the throttle cable through the slot in
C
• Align the projection a on the right handlebar
• Apply a thin coat of rubber adhesive onto the
• There should be 1 ~ 2 mm (0.04 ~ 0.08 in) of
9. Adjust:
• clutch cable free play
4 - 50
HANDLEBAR
Refer to "FRONT BRAKE".
the inside of the throttle grip with a thin coat
of the lithium-soap-based grease, and then
install the throttle grip onto the handlebar.
the right handlebar switch, and then install
the cable.
switch with the hole b in the handlebar.
grip end.
clearance c between the throttle grip and
the grip end.
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" in chapter 3.
Clutch cable free play (at the end
of the clutch lever)
10 ~ 15 mm (0.39 ~ 0.59 in)
CHAS