Assembling The Brake Shoe Plate - Yamaha YBR125ED 2005 Service Manual

REAR WHEEL, BRAKE SHOE PLATE, AND
a
c
REAR WHEEL SPROCKET
4. Measure:
• brake drum inside diameter a
Out of specification → Replace the wheel.
5. Check:
• brake camshaft
Damage/wear → Replace.
EAS00570

ASSEMBLING THE BRAKE SHOE PLATE

1. Lubricate:
• brake camshaft
• brake shoe plate
2. Install:
• brake camshaft 1
• brake shoe wear indicator 2
• brake camshaft lever
M MMM M MMM M
a. Install the brake camshaft so its punch mark
a is positioned as shown.
b. Align the projection b on the brake shoe
wear indicator with the notch in the brake
camshaft.
c. Align the slot c in the brake camshaft lever
with the notch in the brake camshaft.
d. Check that the brake shoes are properly
positioned.
L LLL L LLL L
WARNING
_
After installing the brake camshaft, remove
any excess grease.
3. Install:
• brake shoe springs 1
• brake shoes
NOTE:
• Do not to damage the springs during installa-
tion.
• Install the brake shoe springs as shown.
4 - 15
CHAS
Brake drum inside diameter limit
(maximum)
131.0 mm (5.16 in)
Recommended lubricant
Lithium-soap-based grease
10 Nm (1.0 m · kg, 7.2 ft · lb)
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
M MMM M MMM
L LLL L LLL