Troubleshooting guide
Gate does not open or close
Gate reverses while closing or
stops while opening
Transmitter not functioning
Gate and/or opener requires
service
36
Elite® - Swing Gate Opener
Check that power is still available at mains power point.
Check that Control Box is plugged into mains power.
Check that motor is engaged for automatic operation.
Check all wiring from motor and microswitches to the control board are
sound.
Check obstruction overload sensitivity adjustment.
Check for obstructions.
Disengage the drive unit to manual and check the gate is in good working
order.
If a P.E. beam is fi tted, ensure it is clear of obstructions or dirt on the lens.
New transmitters must be coded to the receiver.
Check/change the battery in the transmitter (LED fl ashes to indicate low
battery).
Having the antenna behind a structure (gate or fence) or not in line of
sight may reduce optimal range/reception.
Interference from external/outside sources such as baby monitors, or radio
transmitter etc. The best solution is to remove the source causing the
interference.
Contact the installer of the opener or local ATA dealer for service. They
will be able to inspect, service, adjust or repair the gate and opener as
necessary.
Owner Installation Instructions
Need help?
Do you have a question about the Elite and is the answer not in the manual?