Installation - Toro Groundsmaster 7200 Installation Instructions Manual

Installation

Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Sensor module
LED light
Bolt (1/4 x 1-1/4 inch)
Flange nut (1/4 inch)
Bolt (1/4 x 3/4 inch)
Mounting bracket
Wire harness
Alarm
Decal
Cable tie
Decal
No parts required
Determine the left and right sides of the machine from
the normal operating position.
Preparing the Machine
1. Park the machine on a level surface.
2. Disengage the power takeoff and lower the
attachments.
3. Engage the parking brake.
4. Shut off the engine and remove the key.
5. Wait for all movement to stop.
6. Allow machine components to cool.
Qty.
–
Prepare the machine.
1
1
2
4
2
Install the kit.
1
1
1
1
2
1 Install the decal.
–
Calibrate the sensor.
Installing the Kit
Installing the Sensor Module
1. Disconnect the battery. Refer to the Operator's
Manual for disconnecting the battery.
2. Remove the hood on the machine. Refer to the
Operator's Manual for removing the hood.
3. Check the machine frame shown in
for existing holes. If there are existing holes,
proceed to step 6.
2
Use
Figure 1