Installing The Tipper Roller Kit (Optional); Applying The Ce Decals - Toro Reelmaster 3100-D Operator's Manual

1. Wear bar
If the clearance is not in this range, adjust the
rear cylinder as follows:
A. Lower the cutting units and back off the jam
nut on the cylinder
1. Rear cylinder
B. Grasp the cylinder rod close to the nut with
a pliers and rag and rotate the rod.
C. Raise the cutting units and check the
clearance.
D. Repeat steps
E. Tighten the clevis jam nut.
Important:
Lack of clearance at the front stops or
the rear wear bar could damage the lift arms.
14
Installing the Tipper Roller
Kit (Optional)
Parts needed for this procedure:
1 Tipper roller kit (not included)
Procedure
When cutting in higher heights of cut, install the Tipper
Roller Kit.
Figure 28
2. Bumper strap
(Figure 29).
Figure 29
2. Adjusting nut
A through C if necessary.
1. Raise the cutting units all the way up.
2. Locate the frame bracket above the center
cutting unit
3. While pressing down on the front roller of the
center cutting unit, determine which holes on the
tipper bracket align with the frame bracket holes
to attain the same roller contact when the tipper
g008879
bracket is installed
1. Frame bracket
4. Lower the cutting units and mount the tipper
bracket to the frame with the 2 carriage bolts
and 2 nuts supplied with the kit
g008880
15

Applying the CE Decals

Parts needed for this procedure:
1 Warning decal (121-3598)
1 CE decal
1 Production year decal
Procedure
On machines requiring CE compliance, apply the
production year decal (Part No. 133-5615) near the
serial plate, the CE decal (Part No. 93-7252) near
the hood lock, and the CE warning decal (Part No.
121-3598) over the standard warning decal (Part No.
121-3628).
22
(Figure 30).
(Figure 30).
Figure 30
2. Tipper bracket
(Figure
g016925
30).