Contents Of Simulations; Mirror Scanning Operation; Mirror Home Positions Sensor (Mhps) Status Display - Sharp AR-M207 Service Manual

4. Contents of simulations

Main Sub
code code
01 01

Mirror scanning operation

Used to check the operations of the scanner unit and its control circuit.
Enter the number of times and the magnification ratio, and press [OK] key to operate the scanner unit. The
speed is variable according to the specified magnification ratio. The number of scanning can be specified by
entering a value to the right lower section of the LCD.
•Setting range of magnification ratio: 25%-400%
•Setting range of the number of scanning: 0-999 (When 0 is set, it means unlimited. )
(Scan number input window)
Sim1-1 SCAN CHECK
115%
100%
86%
ZOOM
(Execution
window)
Sim1-1 SCAN CHECK
115%
100%
86%
ZOOM
Used to display the status (ON/OFF) of the mirror HP sensor on the LCD during scanning. (Highlighted at
ON)
"EXEC" is displayed to indicate execution is in process. The scan counter is displayed above "EXEC." This
counter is counted up even in simulation.
The copy lamp is lighted during scanning.
[CA] key: Exits the simulation mode.
[Interruption] key: Returns to the sub code input window.
[C] key: Input value clear
10 key: Input of the number of scanning
02

Mirror home positions sensor (MHPS) status display

Used to monitor the mirror home position sensor and display the ON/OF status of the sensor on the LCD.
Sim1-2 SENSOR CHECK
MHPS
[CA] key: Exits the simulation mode.
[Interruption] key: Returns to the sub code input window.
Set the scan magnification ration.
This magnification ratio accords with the scan speed
MHPS
in actual copying. The setting range is 25% - 400%.
123
Specify the scan number to be performed.
100% 5
The setting range is 0 - 999. When 0 is set,
the number is unlimited.
OK/START Key
MHPS sensor status
MHPS
Scan counter
123
100% EXEC
Highlighted during execution
MHPS(MIRROR HOME POSITION SENSOR)
ON :Highlight display
OFF :Normal display
AR-M207 M165 M162 SIMULATIONS 7-3
Contents Remark