Sharp AR-M207 Service Manual page 115

5) PC side:
If "The copier is off." is displayed on the left lower side after booting
the integrated maintenance program, select [File] and then
[Reconnect] on the menu bar.
6) PC side:
Check to confirm that the tree is displayed on [Special (MCU/IMC2/
Panel/ Facsimile)] of the integrated maintenance program. If the tree
is not displayed, check that the USB is properly connected and
select [Reconnect] again in the previous procedure of (5).
7) PC side:
Double click [Special (MCU/IMC2/Panel/Facsimile)] on the main tree
items to extend the sub tree items, and select [DWL Data Area
Download].
AR-M207 M165 M162 FLASH ROM VERSION UP PROCEDURE 12-4
8) PC side:
Specify the download file (*.dwl).
9) PC side:
When the DWL data file is specified, the DWL data file is transferred
from the PC to the machine. Downloading is proceeded
automatically.
10) PC side:
When the message below is displayed, download is completed.
Completion message:
Download is completed. Do not turn the copier power off until
"Processing finished. Turn off the power." is displayed on the copier.
NOTE (Important):
• Be sure that the power is not turned off and the USB cable is not
removed until the word "OFF" appears.
11) Main body side:
Wait until the word "Processing finished.Turn off the power." appears
on the operation panel.
The appearance of "Processing finished.Turn off the power."
indicates the completion of the download (writing into ROM).
Turn the power off and the USB cable can be removed at this point.