Total Counter Display Change Setting; Paper Sensor Status Display; Document Size Detection Photo Sensor Check - Sharp AR-M207 Service Manual

Main Sub
code code
26 74

Total counter display change setting

Used to set whether the scanner counter value is added to the total counter display in the key operator
program.
Sim26-74 ADD COUNT
1:ADD SCAN CNT
[ 0- 1]
[CA] key: Exits the simulation mode.
[Interruption] key: Shifts to the sub code input window.
30 01

Paper sensor status display

Used to display the list of paper sensor status on the LCD. An active sensor is highlighted.
The display items and corresponding sensors are shown below.
Sim30-1 SENSOR
POUT DPX
MBEMP C1EMP C2EMP
C3EMP C4EMP
C3PSS C4PSS
When a multi-stage cassette is not installed as an option, the corresponding sensor name is not displayed.
41 01

Document size detection photo sensor check

Used to check the operation of the document sensor.
When this simulation is executed, the status of the document sensor is displayed.
An active sensor display is highlighted.
Sim41-1 PD SENSOR
OCSW PD1
PD3 PD4
OC cover open/close sensor status
OCSW
* For AB series, PD1-PD5; for inch series, PD1 - PD4.
0 : Scan counter not added
1 : Scan counter added
0
0
Display : Corresponding sensor
PIN POUT : Paper exit sensor
DPX : DUPLEX sensor
PIN : Paper entry sensor
C2PSS
DRST MBEMP : Manual feed paper sensor
C1EMP : No. 1 tray paper sensor
C2EMP : No. 2 tray paper sensor
C3EMP : No. 3 tray paper sensor
C4EMP : No. 4 tray paper sensor
C2PSS : No. 2 tray paper feed sensor
C3PSS : No. 3 tray paper feed sensor
C4PSS : No. 4 tray paper feed sensor
DRST : New drum sensor (AL model only)
PD2
PD5
Open Close
Highlighted Normal display
AR-M207 M165 M162 SIMULATIONS 7-25
Contents
Document sensor status
PD1 - PD5 Document NO Document
Normal display Highlighted
Default:
0 (Scan counter not
added)
YES
Remark