Single Paper Feeder(Spf)Aging; Spf Sensor Status Display; Spf Motor Operation Check - Sharp AR-M207 Service Manual

Main Sub
code code
02 01

Single Paper Feeder(SPF)aging

Used to check the operations of the SPF unit and its control circuit.
Enter the magnification ratio and press OK or [START] key to drive the SPF unit at the speed corresponding
to the setting.
(Magnification ratio selection window)
Sim2-1 SPF AGING
115%
100%
86%
ZOOM 100%
(Execution
window)
Sim2-1 SPF AGING
115%
100%
86%
ZOOM 100%
* When [Interruption] key is press, the simulation is terminated and the machine returns to the sub code
input window.
* When [CA] key is pressed, the simulation is terminated and the machine exits the simulation mode.
02

SPF sensor status display

Used to display the sensor status in the SPF/RSPF section. An active sensor is highlighted.
Sim2-2 SENSOR CHECK
SPFP L1
OCCV L2
POUT W0
SPFC W1
[CA] key: Exits the simulation mode.
[Interruption] key: Returns to the sub code input window.
03

SPF motor operation check

Used to check the operation of the SPF motor and its control circuit. When this simulation is executed, the
initial menu shown below is displayed. Select the magnification ratio to drive the motor.
(Initial window = Magnification ratio selection window)
Sim2-3 OUTPUT CHECK
115%
100%
86%
ZOOM 100%
(Execution
window)
Sim2-3 OUTPUT CHECK
115%
100%
86%
ZOOM 100%
[CA] key: The SPF motor is stopped, and the machine exits the simulation mode. [Interruption] key: The SPF
motor is stopped, and the machine returns to the sub code input window.
Select the scan magnification ratio (drive speed).
This also accords with the magnification ratio and
1SIDE
the speed in copying similarly to the OC.
2SIDE
The setting range is 50% - 200%.
EXEC
OK/START Key
1SIDE
"EXEC" is highlighted during execution.
2SIDE
EXEC
Displayed name
SPFP :SPF document transportation sensor
W2
OCCV :SPF unit (OC cover) open/close sensor
W3
POUT :SPF paper exit sensor
SPFC :SPF paper feed cover open/close sensor
L1 :SPF paper length sensor 1
L2 :SPF paper length sensor 2
W0 :SPF document set sensor
W1 :SPF paper width sensor (small)
W2 :SPF paper width sensor (middle)
W3 :SPF paper width sensor (large)
Select the scan magnification ratio (drive speed).
This also accords with the magnification ratio and
the speed in copying.
The setting range is 50% - 200%.
EXEC
OK/START Key
"EXEC" is highlighted during execution.
EXEC
AR-M207 M165 M162 SIMULATIONS 7-4
Contents
: Sensor name
Remark