Memory Reverse Position Adjustment In Duplex Copy - Sharp AR-M207 Service Manual

Main Sub
code code
50 18

Memory reverse position adjustment in duplex copy

Used to adjust the reverse point (scanning end position) on the reversed surface in duplex copy.
When this simulation is executed, the selection window of the adjustment items and the current set value
are displayed
(Adjustment item selection window)
Sim50-18 DUP REV.
1:OC
2:SPF
[
The adjustment value is in the range of 1 - 99. (Default: 50)
Front surface print in S-D mode and even page print in D-S mode are reverse memory copy operations from
the document rear edge.
When, therefore, the print start position adjustment of the output image is required, adjust as follows:
The image in the reverse memory copy is printed from the scanning rear edge when the document scanning
direction is in the arrow direction as shown below.
If, therefore, the print lead edge is shifted, set the reference chart with the rear edge on the reference
position, and adjust the simulation set value with this simulation so that the print image lead edge matches.
Since printing is started at the print start position from the last memory image data to the head data, the end
data position saved in the memory is changed by changing the scanning end position with the simulation,
adjusting the image lead edge position.
Document transport
direction
Scan direction
Select an adjustment item (mode) with the cross key, and enter the set value with 10-key.
When [OK] key is pressed, the entered value is saved to the EEPROM and the machine shifts to the copy
execution window.
After completion of copying, the machine returns to the adjustment value input window.
When [START] key is pressed instead of [OK] key, the machine shifts to the copy execution window and
performs copying.
(Copy start window)
Ready to copy.
S
100%
8 1/2 11
(Copy execution window)
Copies in progress.
S
100%
8 1/2 11
Display text array : Adjustment mode
1: OC
50
2: SPF
50
1- 99] 50
Scan lead edge
Scan end position
(Default: Void (1) is not scanned.)
Scan rear edge
AR-M207 M165 M162 SIMULATIONS 7-44
Contents
: OC memory reverse output position
: SPF memory reverse output position
Paper transport
direction
BACK
Adjustment
Copy start
OK
item selection
window
window
START
Copy execution
START
window
End of copy execution
Remark
Print lead edge
Lead edge void (1
Print start position
Rear edge void
Print rear edge