Version Confirming Procedure; Forbidden Actions While Downloading; If The Above Inhibit Item Occurs During Downloading - Sharp AR-M207 Service Manual

12) Terminate the maintenance program, and turn on the power of the
main body.
NOTE:
• For making a second connection with another machine, select the [File]
and [Reconnect] in the menu bar on the maintenance program at the
time of the USB being re-connected. Repeat the previous procedures
from the above 5).
* Forbidden actions while downloading (Important)
Failure in the download concerned may not allow you to conduct the
subsequent download procedures. Added care should be taken to avoid
having the situation below arise while downloading.
•Switching off the main body of AR-M207/M162/M165.
•Disconnecting the download cable (USB cable).

* If the above inhibit item occurs during downloading:

Turn OFF and ON the power.
1) If "Download mode." (which means downloading) is displayed on the
operation panel of the machine, perform downloading again.
2) If "Download mode." (which means downloading) is not displayed on
the operation panel of the machine, turn OFF the power, and press
and hold the 4 key and the CA key and turn ON the power. If, then,
"Download mode." (which means downloading) is displayed on the
operation panel LED of the machine, perform downloading again.
If "Download mode." is still not displayed, the MCU/Panel/IMC2/Fax
must be replaced.
AR-M207 M165 M162 FLASH ROM VERSION UP PROCEDURE 12-5

4.Version confirming procedure

1) Machine side:
Execute the service simulation No. 49-01 (Flash ROM program
writing mode).
(A word "Download mode." appears on the operation panel to denote
the download mode status. )
2) Connect the main unit and the PC with a USB cable. (Be sure to
connect the USB cable to the main unit side. Connection to the
optional dual function board cannot execute this function.)
3) PC side:
Boot "Maintenance.exe" and select [AR-M207/M162/M165 Series]
on the model selection menu.
4) PC side:
Check to confirm that "Simulation Command List" tree is displayed
on the integrated maintenance program.
5) PC side:
If "The copier is off." is displayed on the left lower side after booting
the integrated maintenance program, select [File] and then
[Reconnect] on the menu bar.