Main
Sub
code
code
02
08
SPF paper feed solenoid operation check
Used to drive the SPF paper feed solenoid (PSOL) 20 times in the cycle of 500msec of "ON" and 500msec
of "OFF." After completion of the process, the machine returns to the sub code input window.
(Initial window)
Sim2-8 SPUS CHECK
PRESS OK KEY EXEC
When [Interruption] key is pressed, the machine returns to the sub code input window.
When [CA] key is pressed, the machine exits the simulation mode.
09
RSPF reverse solenoid operation check
Used to drive the SPF reverse solenoid (RSOL) 20 times in the cycle of 500msec of "ON" and 500msec of
"OFF." After completion of the process, the machine returns to the sub code input window.
(Initial window)
Sim2-9 SPFS CHECK
PRESS OK KEY EXEC
When [Interruption] key is pressed, the machine returns to the sub code input window.
When [CA] key is pressed, the machine exits the simulation mode.
10
RSPF paper exit gate solenoid operation check
Used to drive the SPF paper exit gate solenoid (GSOL) 20 times in the cycle of 500msec of "ON" and
500msec of "OFF." After completion of the process, the machine returns to the sub code input window.
(Initial window)
Sim2-10 SGS CHECK
PRESS OK KEY EXEC
When [Interruption] key is pressed, the machine returns to the sub code input window.
When [CA] key is pressed, the machine exits the simulation mode.
11
SPF PS release solenoid operation check
Used to drive the SPF PS release solenoid (CLH) 20 times in the cycle of 500msec of "ON" and 500msec of
"OFF." After completion of the process, the machine returns to the sub code input window.
(Initial window)
Sim2-11 CLH CHECK
PRESS OK KEY EXEC
When [Interruption] key is pressed, the machine returns to the sub code input window.
When [CA] key is pressed, the machine exits the simulation mode.
03
02
Shifter/job separator sensor status display
Used to monitor the sensors related to the shifter and the job separator and display the sensor status on the
LCD. An active sensor is highlighted.
Sim3-2 SENSOR
SFTHP
JSUP
TRYF
TRYD
* Displayed only when the job separator is installed except for SFTH.
Contents
(Execution window)
Sim2-8 SPUS CHECK
OK/START Key
(Execution window)
Sim2-9 SPFS CHECK
OK/START Key
(Execution window)
Sim2-10 SGS CHECK
OK/START Key
(Execution window)
Sim2-11 CLH CHECK
OK/START Key
Displayed name :Sensor name
SFTHP
:Shifter home position sensor
JSDL
JSUP
:Job separator upper limit sensor
JSDL
:Job separator lower limit sensor
TRYF
:Tray full sensor
TRYD
: Paper exit sensor
AR-M207 M165 M162 SIMULATIONS 7-5
EXEC
EXEC
EXEC
EXEC
Remark