Contents Of Simulations - Sharp AR-162 Service Manual

4. Contents of simulations

Main Sub
Contents
code code
1 1 Mirror unit operation check
2 Optical system sensor
operation check
2 1 SPF aging
<Only when an
SPF/RSPF is installed>
2 SPF sensor operation
check
<Only when an
SPF/RSPF is installed>
3 SPF motor forward
rotation operation check
<Only when an
SPF/RSPF is installed>
4 SPF motor reverse
rotation operation check
<Only when an
SPF/RSPF is installed>
8 SPF paper feed solenoid
operation check
<Only when an
SPF/RSPF is installed>
9 RSPF reverse solenoid
operation check
<Only when an RSPF is
installed>
10 RSPF paper exit gate
solenoid operation check
<Only when an RSPF is
installed>
11 SPF PS release solenoid
operation check
<Only when an
SPF/RSPF is installed>
Details of operation
Used to execute scanning at the speed corresponding to the set
magnification ratio.
Key operation
Changing the magnification ratio:
Fixed magnification ratio key
ZOOM UP KEY, ZOOM DOWN
KEY
Used to check MHPS (Mirror home position sensor) ON/OFF state with
the LED on the operation panel.
<Lighting when the sensor is ON>
MHPS: Paper empty LED
Used to perform SPF document transport.
The paper size is not detected. (Excluding postcards, extra large sheet
of 1m or greater.)
With SPF installed: Single transport operation
With RSPF installed: Duplex transport operation
Key operation
Changing the magnification ratio:
Fixed magnification ratio key
ZOOM UP KEY, ZOOM DOWN
KEY
Used to check sensors in SPF with the LED on the operation panel.
<Lighting at sensor ON>
PW1: JAM LED
PW2: Paper empty LED
PW3: Machine position JAM LED
PW4: SPF JAM LED
PL1: Manual paper feed tray select LED
PL2: 2nd tray position JAM LED
P-IN: SPF select LED
SPF COVER OPEN: Main cassette select LED
Used to rotate the SPF motor forward for 10 sec.
Used to rotate the SPF motor reversely for 10 sec.
Used to drive the SPF paper feed solenoid (PSOL) at the cycle of 500
msec ON and 500 msec OFF 20 times.
Used to drive the RSPF reverse solenoid (RSOL) at the cycle of 500
msec ON and 500 msec OFF 20 times.
Used to drive the RSPF paper exit gate solenoid (GSOL) at the cycle of
500 msec ON and 500 msec OFF 20 times.
Used to drive the SPF PS release solenoid at the cycle of 500 msec ON
and 500 msec OFF 20 times.
AR-162 SIMULATIONS – 2
Display
Set magnification ratio:
Fixed magnification ratio LED
ZOOM LED
Display
Display
Set magnification ratio:
Fixed magnification ratio LED
ZOOM LED
Display
Initial
Set range
value
50 ∼ 200%
100%
50 ∼ 200%
100%