Table of Contents
Advertisement
Operating Instructions
Chapter 16 — Map Editor
You can register a map to monitor video from cameras, event detection and input/output device's status of
devices registered on the NVR system on a map on the Client system.
NOTE: This function is supported only for devices which use the iNEX protocol, but monitoring video from
cameras supported also for devices which use the Axis or ONVIF Conformance protocol.
16.1 Registering Map
1. Go to the Start menu, and click iNEX Setup, and select the Device menu.
2. Click Map in the Site panel, and then the
Map Editor window appears.
3. Select an input/output device connected to a device or a sub-map in the Site panel and drag and drop it
on the canvas.
4. Set up the map. Refer to 16.2 Setting up Map (p. 122) for details.
5. Entering a map name and clicking the OK button completes registration of the map.
118
button at the bottom of the Site List panel on the right. The
- Quick Links:
- Factory Reset
Hide quick links:
Advertisement
Table of Contents
