Table of Contents
Advertisement
User's Manual
The Information column displays whether the device is being used or not. Other indicates the device has been used
for another DVR.
Highlight the box in the Information column for the desired storage device and press the
Highlight the box in the Setup column and press the
up to record the same data on the two disks at the same time. Refer to the Chapter 4 – Disk Mirroring for further
information on setting up disk mirroring.
System Event
The DVR can be configured to run self-diagnostics and report the results.
Highlight the Settings box beside the desired event (System, Check Recording, Check Alarm-In, Disk Almost Full,
Disk Bad, or Disk Temperature), and press the
Highlight the Settings box beside System and press the
to run self-diagnostics on the system. You can select from 1 hr. to 30 days or Never.
26
You will be able to check the model name, serial number and the time information
about recorded data of the selected storage device.
If you want to erase recorded data on the selected device, highlight Clear and press
the
button. You will be asked whether or not you want to delete the data.
button(RAID supported models only). The DVR can be set
Figure 12: System – System Event setup screen.
button.
button. You can select the interval that you want the DVR
button.
Advertisement
Table of Contents
