Chapter 8 - Event Handling; Handling A Monitoring Event - Eneo PNR-5104 Operating Instructions Manual

Operating Instructions
Chapter 8 — Event Handling
You can monitor video from a camera where an event is detected and play back event-recorded video. Event
related functions may not be supported depending on the protocol that the device uses (supported for the
iNEX protocol and some versions of the ONVIF
First, check the following and run the Client program.
 The NVR system should be running.
 Devices should be added to a device group. Refer to Chapter 12 — Device Management (p. 95) for
details.
 There should be recorded data in the storage. Refer to Chapter 6 — Recording (p. 59) for details.
 The event detection functions of the device should be enabled.

8.1 Handling a Monitoring Event

You can monitor live video from a camera where an event is detected or play back event-recorded video
if video of the selected event has been recorded.
Motion Detection
Audio Detection
/ Alarm-In On/Off
System Alive
/ External Storage In/Out
76
The event list displays live and callback events from the registered devices. The
callback events are listed only when the remote callback function is set up in the
device.
You can change the options of the event list display during Menu – Preference
Settings. Refer to 4.3 Client, Menu – Preference Settings (p. 37) for
details.
The description of event icons which are displayed in the event list is as follows
(some event icons may not be supported, depending on the specifications and version
of the device):
Video Blind
Trip-Zone
/ Alarm-In Bad/Good
System Restart
/ Device Connected/Disconnected
TM
Conformance and Axis protocol).
Video Loss
Tampering
System Boot Up
System Shut Down