Eneo PNR-5104 Operating Instructions Manual page 70

Operating Instructions
Pre-Event Recording Condition
The NVR system records video prior to event detection when predefined events are detected (supported
only for devices which use the iNEX protocol).
3. Double click the Action schedule window, and then select a desired Preset (supported only for devices
which use the iNEX protocol).
4. Select the cameras to record after double clicking the Target schedule window.
62
A stream to use for recording (network cameras only) or a
codec, resolution, frame rate and quality settings (network
video transmitters only) are allocated to each Preset. The
stream or settings allocated to each Preset is different
depending on the device. Refer to 12.2 Managing
Devices, Editing Device Information (p. 93) for details.
 Duration: Set up the duration (maximum of 60 seconds)
of recording when a predefined event is detected. For
Event recording, the system records video for the duration
from the time an event is detected. For Pre-Event
recording, the system records video for the duration
prior to event detection.
Select cameras from the device list or device groups from the device
group list from which to record video whenever any predefined event
is detected. Selecting the Same cameras that triggered an event
option records video only from the camera where the predefined
event is detected (not supported for alarm-in events and audio
detection events). The Same cameras that triggered an event
option is not supported for Pre-Event recording.
Enter the Preset name and select Pre
Event Condition from the Condition
Type list.