16. Remove the snap ring holding the oil pump driven
gear.
NOTE: Always use a new snap ring when installing
the oil pump driven gear.
17. Remove oil pump driven gear. Account for the drive
pin and thrust washer.
AT THIS POINT
To service clutch components, see Servicing Right-Side
Components sub-section.
G. Oil Pump/Oil Strainer
NOTE: Steps 1-17 in the preceding sub-sections
must precede this procedure.
18. Remove three cap screws holding the oil pump and
remove the oil pump. Account for two alignment
pins.
50
MD1017
19. Remove the four cap screws securing the oil strainer
cap; then remove the Phillips-head screws securing
the oil strainer. Account for the O-ring.
MD1019
To service center crankcase components only, proceed
MD1020
to Separating Crankcase Halves.
Servicing Right-Side
NOTE: Whenever a part is worn excessively,
cracked, damaged in any way, or out of tolerance,
replacement is necessary.
Manual
Table of Contents
AT THIS POINT
Components
MD1060
MD1207