Back-Up Lights; Running Lights - Arctic Cat 450 XC 2011 Service Manual

2. Turn the bulb socket assembly counterclockwise and
remove from the housing.
3. Press in and turn the bulb counterclockwise to
remove. Press in and turn clockwise to install the
bulb.
4. Insert the bulb socket assembly into the housing and
turn it clockwise to secure.
5. Secure the housing cover with the two fasteners.

RUNNING LIGHTS

The running lights are located outboard of the headlights.
To replace the running light bulbs, use the following pro-
cedure.
1. Rotate the bulb socket counterclockwise to release
from light housing; then press in on the bulb and turn
counterclockwise to release from the socket.
2. Install a new bulb and press in rotating clockwise to
secure; then place the socket into the light housing
and turn clockwise to secure.
14
KC433A

BACK-UP LIGHTS

The back-up lights are located outboard of the taillights/
brakelights. To replace the back-up light bulbs, use the
following procedure.
1. Remove the taillight housing cover (see taillights-
brakelights in this section).
2. Remove two screws securing the back-up light
socket to the taillight housing. Account for a small
gasket.
KC434A
3. Twist the bulb counterclockwise and remove from
the socket; then press in and rotate the new bulb
clockwise.
4. Secure the socket to the housing making sure the
gasket is in place.
5. Install the housing cover.
KC428A
Manual
Table of Contents
KC428B
KC435A
KC436A