Assembling Input Shaft - Arctic Cat 450 XC 2011 Service Manual

3. Using a side-cutter (or suitable substitute), remove
the boot clamps; then remove the boots and splined
drive from the input shaft.
4. Remove the input shaft from the pinion housing.
5. Using the Multi-Seal Remover, remove the input
shaft seal. Account for a spacer.
6. Remove the snap ring securing the input shaft bear-
ing; then place the pinion housing in a press and
remove the bearing.
94
CD106
CD107

Assembling Input Shaft

1. Place the pinion housing in a press and install the
input shaft bearing. Secure the bearing with the
existing snap ring making sure the sharp edge of the
snap ring faces to the outside.
AF982
Manual
Table of Contents
AF983
AF984
KX219
AF993