Genuine Parts; Preparation For Storage; Filling Gas Tank - Arctic Cat 450 XC 2011 Service Manual

The recommended oil to use is Arctic Cat ACX All
Weather synthetic engine oil, which has been specifically
formulated for use in this Arctic Cat engine. Although
Arctic Cat ACX All Weather synthetic engine oil is the
only oil recommended for use in this engine, use of any
API certified SM 5W-50 oil is acceptable.
RECOMMENDED FRONT
DIFFERENTIAL/REAR DRIVE
LUBRICANT
The recommended lubricant is Arctic Cat Gear Lube or
an equivalent gear lube which is SAE approved 80W-90
hypoid. This lubricant meets all of the lubrication
requirements of the Arctic Cat ATV front differentials
and rear drives.
CAUTION
Any lubricant used in place of the recommended lubri-
cant could cause serious front differential/rear drive
damage.

FILLING GAS TANK

! WARNING
Always fill the gas tank in a well-ventilated area. Never
add fuel to the ATV gas tank near any open flames or
with the engine running. DO NOT SMOKE while filling
the gas tank.
Since gasoline expands as its temperature rises, the gas
tank must be filled to its rated capacity only. Expansion
room must be maintained in the tank particularly if the tank
is filled with cold gasoline and then moved to a warm area.
4
Do not overflow gasoline when filling the gas tank. A
fire hazard could materialize. Always allow the engine to
cool before filling the gas tank.
Tighten the gas tank cap securely after filling the tank.
Do not over-fill the gas tank.
When replacement of parts is necessary, use only genuine
Arctic Cat ATV parts. They are precision-made to ensure
high quality and correct fit. Refer to the Illustrated Parts
Manual for the correct part number, quantity, and
OILCHARTI description.

Preparation For Storage

Prior to storing the ATV, it must be properly serviced to
prevent rusting and component deterioration.
1. Clean the seat cushion (cover and base) with a damp
cloth and allow it to dry.
2. Clean the ATV thoroughly by washing dirt, oil,
grass, and other foreign matter from the entire ATV.
Allow the ATV to dry thoroughly. DO NOT get
water into any part of the engine or air intake.
3. Either drain the gas tank or add Fuel Stabilizer to the
gas in the gas tank. Remove the air filter housing
cover and air filter. Start the engine and allow it to
idle; then using Arctic Cat Engine Storage Preserver,
rapidly inject the preserver into the air filter opening
for a period of 10 to 20 seconds; then stop the
engine. Install the air filter and housing cover.
If the interior of the air filter housing is dirty, clean the
area before starting the engine.
4. Plug the exhaust outlet on the muffler with a clean
cloth.
5. Apply light oil to the upper steering post bushing and
plungers of the shock absorbers.
6. Tighten all nuts, bolts, cap screws, and screws. Make
sure rivets holding components together are tight.
Replace all loose rivets. Care must be taken that all
calibrated nuts, cap screws, and bolts are tightened to
specifications.
7. Fill the cooling system to the bottom of the stand
ATV0049B pipe in the radiator neck with properly mixed cool-
ant.
Manual
Table of Contents
! WARNING
! WARNING

Genuine Parts

CAUTION
CAUTION