Seat - Arctic Cat 450 XC 2011 Service Manual

2. Remove two reinstallable rivets securing the fenders
to the footwells.
3. Using a small screwdriver, remove the light connec-
tors from the frame; then disconnect both connectors
and remove the rear body panel/fender.
CLEANING AND INSPECTING
 NOTE: Whenever a part is worn excessively, cracked,
or damaged in any way, replacement is necessary.
1. Clean all rear body panel components with warm
soap and water.
2. Inspect side panels and rear body panel for cracks
and loose rivets.
3. Inspect threaded areas of all mounting bosses for
stripping.
4. Inspect for missing decals.
INSTALLING
1. Place the rear body panel/fender in place on the
ATV; then secure with the cap screws on the frame
and fender supports. Tighten all fasteners securely.
KC473A
2. Connect the light connectors and secure to the frame.
KC472A
3. Secure the rear fenders to the footwells with the
reinstallable rivets and lock.
4. Install the seat.
REMOVING/INSTALLING
1. To remove the seat, pull rearward on the latch release
(located under the rear of the seat). Raise the rear of
the seat and slide it rearward.
KC472A
2. To lock the seat into position, slide the front of the
seat into the seat retainers and push down firmly on
the rear of the seat. The seat should automatically
lock into position.
Manual
Table of Contents

Seat

KC279
121