Arctic Cat 450 XC 2011 Service Manual page 54

7. Install the clutch shoe assembly on the crankshaft;
then install the flange nut (left-hand thread) (coated
with red Loctite #271). Tighten to 147 ft-lb.
 NOTE: The flat side of the flange nut should be
directed towards the clutch shoe.
CAUTION
Care must be taken when installing the flange nut; it
has "left-hand" threads.
8. Install the one-way clutch making sure that the green
dot or the word OUTSIDE is directed away from the
crankcase.
B. Clutch Cover
C. Fixed Drive Face
D. Movable Drive Face
 NOTE: Steps 1-8 in the preceding sub-section must
precede this procedure.
9. Install two alignment pins and place the clutch cover
gasket into position. Install the clutch cover.
10. Tighten the clutch cover cap screws to 8 ft-lb.
11. Install the air intake plate. Apply red Loctite #271 to
the threads of the three Phillips-head cap screws;
then install and tighten securely.
MD1286
12. Place the driven pulley assembly into position and
secure with the nut (threads coated with red Loctite
#271). Tighten to 147 ft-lb.
MD1115
Manual
Table of Contents
MD1117
MD1342
MD1068
KC134
53