Inspecting Stator/Magneto Cover Assembly; Replacing Starter Gear Bearing - Arctic Cat 450 XC 2011 Service Manual

2. Thoroughly clean the rotor/flywheel; then install the
new one-way clutch and secure with the cap screws
after applying a drop of red Loctite #271 to the
threads. Tighten to 26 ft-lb using a crisscross pattern.
Make sure the one-way bearing is installed with the
notches directed away from the rotor/flywheel.
REPLACING STARTER GEAR
BEARING
1. Support the starter clutch gear in a press making sure
to support the hub around the entire circumference;
then using a suitable bearing driver, press the bearing
from the gear.
44
FI570
2. Thoroughly clean the gear hub; then apply a drop of
green Loctite #620 to the bearing outer race and
press into the gear hub until even with the lower
chamfer radius.
INSPECTING STATOR/MAGNETO
FI576A
COVER ASSEMBLY
1. Inspect the stator for burned or discolored wiring,
broken or missing hold-down clips, or loose cap
screws.
2. Inspect the bearings in the magneto housing for dis-
coloration, roughness when rotated, and secure fit in
bearing bores.
3. Inspect the oil pressure relief valve for evidence of
metal chips or contamination. Do not disassemble
the valve.
FI578
Manual
Table of Contents
FI583
FI580
FI588