Installing The Chassis Feet (Pedestal Configuration Only); Figure 105. Removing The Chassis Feet; Figure 106. Installing The Chassis Feet - Intel S2600CP Service Manual

Hardware Installations and Upgrades
3. Loose the screws securing the rubber foot to the chassis and then remove the rubber foot from
chassis.
4. Repeat above steps until all four feet are removed.

Installing the Chassis Feet (Pedestal Configuration Only)

/
NOTE
Do not install feet on your Intel
rack. Only install feet on a pedestal-configured chassis.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Lay the chassis down on its right side.
4. Insert rubber foot into chassis hole (see letter "A").
5. Secure foot by inserting screw through the rubber foot (see letter "B").
6. Repeat above steps until all four feet are installed.
64 Intel

Figure 105. Removing the Chassis Feet

®
Server Chassis P4000M family if it is to be installed in a

Figure 106. Installing the Chassis Feet

®
Server Board S2600CP Family Intel
®
Server System P4000CP Family Service Guide