Show Dos_Prevention - D-Link DES-1210-28/ME Reference Manual

Restrictions
Example usage:
To configure a land attack and blat attack prevention:
DES-1210-28/ME:5# config dos_prevention dos_type blat_attack action
drop
Command: config dos_prevention dos_type blat_attack action drop
Success!
DES-1210-28/ME:5#

show dos_prevention

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display DoS prevention information:
DES-1210-28/ME:5# show dos_prevention
Command: show dos_prevention
DosType
Land Attack
Blat Attack
Smurf Attack
Tcp Null Scan
Tcp Xmascan
Tcp Synfin
Tcp Syn Srcport less 1024
Success!
DES-1210-28/ME:5#
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
priority – Change packet priority by the Switch from 0 to 7.
If the priority is not specified, the original priority will be used.
rx_rate – controls the rate of the received DoS attack packets.
If not specified, the default action is drop.
•
Only administrator or operate-level users can issue this command.
Used to display DoS prevention information.
show dos_prevention { land_attack | blat_attack | smurf_attack |
tcp_null_scan | tcp_xmascan | tcp_synfin |
tcp_syn_srcport_less_1024 }
The show dos_prevention command is used to display DoS
prevention information, including the type of DoS attack, the
prevention state, the corresponding action if the prevention is
enabled, and the counter information of the DoS packet.
The type of DoS attack. Possible values are as follows:
land_attack, blat_attack, smurf_attack, tcp_null_scan, tcp_xmascan
tcp_synfin and tcp_syn_srcport_less_1024.
None.
State Action
Disabled Mirror
Disabled Mirror
Disabled Mirror
Disabled Mirror
Disabled Mirror
Disabled Mirror
Disabled Mirror
35
Frame Counts
0
0
0
0
0
0
0