Clear Dos_Prevention Counters; Enable Dos_Prevention Trap_Log - D-Link DES-1210-28/ME Reference Manual

To display DoS prevention information for Land Attack:
DES-1210-28/ME:5# show dos_prevention land_attack
Command: show dos_prevention land_attack
DoS Type: Land Attack
State: Disabled
Action: Mirror
Port: 7
Priority: 5
Rx Rate(Kbit/sec): 1024
Frame Counts: 0
Success!
DES-1210-28/ME:5#

clear dos_prevention counters

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To clear all counters of the prevention of each smurf attack:
DES-1210-28/ME:5# clear dos_prevention counters smurf_attack
Command: clear dos_prevention counters smurf_attack
DES-1210-28/ME:5#

enable dos_prevention trap_log

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable a DoS prevention trap/log:
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to clear the counters of the prevention of each DoS attack.
clear dos_prevention counters [land_attack | blat_attack |
smurf_attack | tcp_null_scan | tcp_xmascan | tcp_synfin |
tcp_syn_srcport_less_1024]
The clear dos_prevention counters command is used to clear the
counters of the prevention of each DoS attack.
The type of DoS attack. Possible values are as follows:
land_attack, blat_attack, smurf_attack, tcp_null_scan, tcp_xmascan
tcp_synfin and tcp_syn_srcport_less_1024.
Only Administrator-level users can issue this command.
Used to enable a DoS prevention trap/log.
enable dos_prevention trap_log
The enable dos_prevention trap_log command is used to send
traps and logs when a DoS attack event occurs. The event will be
logged only when the action is specified as drop.
None.
Only Administrator-level users can issue this command.
36