Disable Autoconfig; Show Autoconfig; Save - D-Link DES-1210-28/ME Reference Manual

disable autoconfig

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To stop the auto configuration function:

show autoconfig

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the autoconfig status:

save

Purpose
Syntax
Description
Parameters
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
Use this to deactivate auto configuration from DHCP.
disable autoconfig
The disable autoconfig command is used to instruct the Switch not
to accept auto configuration instruction from the DHCP server. This
does not change the IP settings of the Switch. The ipif settings will
continue as DHCP client until changed with the config ipif command.
None.
Only Administrator-level users can issue this command. .
DES-1210-28/ME:5# disable autoconfig
Command: disable autoconfig
Success.
DES-1210-28/ME:5#
Used to display the current autoconfig status of the Switch.
show autoconfig
The show autoconfig command is used to list the current status of
the auto configuration function.
None.
None.
DES-1210-28/ME:5# show autoconfig
Command: show autoconfig
Autoconfig State: Enabled
DES-1210-28/ME:5#
To save changes in the Switch's configuration to non-volatile RAM.
save {[config config_id <value 1-2> | log | account]}
The save command used to enter the current switch configuration
into non-volatile RAM. The saved switch configuration will be loaded
into the Switch's memory each time the Switch is restarted.
config – Used to save the current configuration to a file.
config_id <value 1-2> - Specifies which cfg file ID. if cfg ID is not
specified, it refers to the boot_up CFG file.
17