Show Loopdetect - D-Link DES-1210-28/ME Reference Manual

Example usage:
To configure the loop back detection with interval time 500 on the Switch:

show loopdetect

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the loop back detection information on the Switch:
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
DES-1210-28/ME:5# config loopdetect interval_time 500
Command: config loopdetect interval_time 500
Success!
DES-1210-28/ME:5#
To display the loop back detection information on the Switch.
show loopdetect {ports [<portlist> | all]}
The show loopdetect command displays the loop back detection
information on the Switch.
<portlist> − A port or range of ports to be displayed.
all − All ports settings are to be displayed.
None.
DES-1210-28/ME:5# show loopdetect
Command: show loopdetect
Loopdetect Global Settings
----------------------------------
Loopdetect Status
Loopdetect Mode
Loopdetect Interval : 100
Recover Time
DES-1210-28/ME:5#
: Enabled
: Port-Base
: 60
33