Lacp Commands; Config Lacp Port_Priority; Show Lacp - D-Link DES-1210-28/ME Reference Manual

The LACP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

config lacp port_priority

show lacp

Each command is listed in detail, as follows:
config lacp port_priority
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the LACP priority of ports 1-5:
DES-1210-28/ME:5# config lacp port_priority 1-5 100 timeout long
Command: config lacp port_priority 1-5 100 timeout long
Success
DES-1210-28/ME:5#
show lacp
Purpose
Syntax
Description
Parameters
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
<portlist> <value 1-65535> [timeout <long | short>]
{<portlist>}
To set the priority value of a physical port in an LACP group.
config lacp port_priority <portlist> <value 1-65535> [timeout
<long | short>]
The config lacp port_priority command sets the LACP priority
value and administrative timeout of a physical port or range of ports
in an LACP group.
<portlist> - A port or range of ports to be configured.
<value 1-65535> - Specifies the LACP priority value for a port or
range of ports to be configured. The default is 1.
<timeout> - Specifies the administrative LACP timeout.
long – Specifies the LACP timeout to be 90 seconds. This is
•
the default.
short – Specifies the LACP timeout to be 3 seconds.
•
Only Administrator or operator-level users can issue this command.
To display current LACP port mode settings.
show lacp {<portlist>}
The show lacp command displays the current LACP mode settings.
<portlist> - A port or range of ports whose LACP settings are to be

LACP COMMANDS

271
41 41 41 41