Igmp Snooping Commands - D-Link DES-1210-28/ME Reference Manual

The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
config igmp_snooping
config igmp_snooping
querier
config igmp_snooping
querier_selection
config igmp_snooping
querier_interval
config igmp_snooping
robustness_variable
create igmp_snooping
multicast_vlan
config igmp_snooping
multicast_vlan
delete igmp_snooping
multicast_vlan
config igmp_snooping
multicast_vlan_group
config igmp_snooping
data_driven_learning
config igmp_snooping
data_driven_learning
clear igmp_snooping
data_driven_group
config igmp_snooping
max_response_time
config router_ports
config router_port
s_forbidden
config igmp
access_authentication
ports
show igmp
access_authentication
ports
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
[vlan_name <string 20> | vlanid <vidlist> | all] [host_timeout <sec 130-153025> |
router_timeout <sec 60-600> | leave_timer <sec 1-25> | fast_leave [enable |
disable] | state [enable | disable]]
[vlan_name <string 20> | vlanid <vidlist> | all] state [enable | disable]
{querier_version [IGMPv2 | IGMPv3]}
[vlan_name <string 20> | vlanid <vidlist> | all] state [enable | disable]
<integer 60-600>
<integer 2-255>
<vlan_name 32> <vlanid 2-4094>
<vlan_name 32> [add | delete] [member_port <portlist> | source_port <portlist> |
tag_member_port <portlist>] state [enable | disable] {replace_source_ip [none |
<ipaddr>]}
<string 32>
<vlan_name 32> [add | delete] <ipaddr>
[all | vlan_name <string 20> | vlanid <vidlist>] [enable | disable] {aged_out}
max_learned_entry <integer 1-256>
[all | vlan_name <vlan_name 20> | vlanid <integer 1-4094>] [all | MCGroupAddr
<ipaddr>]
<integer 10-25>
[vlan_name <string 20> | vlanid <vidlist> | all] [add | delete] <portlist>
[vlan_name <string 20> | vlanid <vidlist> | all] [add | delete] <portlist>
[<portlist> | all] state [enable | disable]
[<portlist> | all]

IGMP SNOOPING COMMANDS

190
30 30 30 30