Basic Ip Commands; Config Ipif System - D-Link DES-1210-28/ME Reference Manual

The Basic IP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

config ipif System

show ipif
Each command is listed in detail, as follows:
config ipif System
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the IP interface System:
DES-1210-28/ME:5# config ipif System dhcp state disable
Command: config ipif System dhcp state disable
% The IP setting mode change to DHCP will cause CLI disconnect.
Success.
DES-1210-28/ME:5#
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
[dhcp | dhcp_option12 {clear_hostname | hostname <hostname 63>} | ipaddress
<network_address> gateway <ipaddr>] state [enable | disable]
To configure the System IP interface.
config ipif System [dhcp | dhcp_option12 {clear_hostname |
hostname <hostname 63>} | ipaddress <network_address>
gateway <ipaddr>] state [enable | disable]
The config ipif System command configures the System IP
interface on the Switch.
system − The IP interface name to be configured. The default IP
Interface name on the Switch is 'System'. All IP interface
configurations done are executed through this interface name.
dhcp − Specifies the DHCP protocol for the assignment of an IP
address to the Switch to use for the DHCP Protocol.
hostname <hostname 63> – Specifies the host name of DHCP.
ipaddress <network_address> − IP address and netmask of the IP
interface to be created. The address and mask information may be
specified
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/16).
gateway <ipaddr> − IP address of gateway to be created.
state [enable | disable] − Enables or disables the IP interface.
Only Administrator or operator-level users can issue this command.

BASIC IP COMMANDS

by using the traditional
179
format (for example,
27 27 27 27