Table of Contents
Advertisement
Telnet Access
Information
By default, the Telnet login credentials are disabled. This setting is required
when using the Matrix controller (Gefen part no. EXT-CU-LAN) but can be
enabled for security purposes. Use the
enable or disable this feature.
1.
Launch the desired terminal application (e.g. Windows Hyperterminal, etc).
2.
Within the terminal program, enter the IP address of the Sender or Receiver unit that
you wish to control.
3.
Enter the TCP listening port. The default listening port is 23.
4.
After the correct settings have been used in the terminal program, information similar
to the following will be displayed.
In the example, below, we are connected to the client (Receiver unit) and Telnet login
has been enabled:
------------- Welcome to the Gefen Telnet Server -----------
ast2-client001C9103C8B3 login:
5.
Login as "Administrator". The default password is "admin". To change the Telnet
password, see the
6.
Type #help for a list of commands or refer to the tables on the following pages.
#set_telnet_pass
page | 62
#use_telnet_login
command.
command to
Advertisement
Table of Contents
