Table of Contents
Advertisement
When using unicast mode, each of the Sender units must be assigned a unique
channel and should never be changed. Use the Receiver unit to switch (channels)
between Sender units.
Multiple Receiver units can simultaneously connect to any Sender unit within the
network including the Gefen KVM over LAN products with HDMI, DVI, or VGA video,
to create a virtual matrix of just over 65,000 Sender and Receiver units, depending
on the network bandwidth and number of ports on the network switch. Although any
combination of HDMI, DVI, and VGA Senders and Receivers can be used, HDCP
content is only supported by HDMI Sender and Receiver units.
Information
In unicast mode, if an additional Sender unit is introduced into a system with
the same channel as another Sender unit, then the Receiver unit will continue
to receive audio/video data from the Sender unit which was connected first.
Unicast & Multicast Modes
page | 27
Advertisement
Table of Contents
