Gefen EXT-HDKVM-LANTX User Manual page 23

18. Click the desired IP Mode button.
• If you will be using Static mode, then enter the IP Address, Subnet Mask, and Default
Gateway. Contact your system administrator if necessary.
• If DHCP mode is selected, then the IP address, subnet mask, and default gateway will
be specified by the DHCP server.
For this example, we will click the DHCP button.
19. Set the video channel. By default, both the Sender and Receiver unit are set
to channel 0. See
20. Click the Save button in the bottom-right corner of the IP Setup window group.
21. Click the Reboot button near the bottom of the page.
22. Repeat steps 12 - 21 for each Sender and Receiver to be configured.
Important
The use of a Gigabit switch with "jumbo frame" capability is required when
connecting the HD KVM over IP to a network. The switch should be set to
greater than 8K.
Setting the Video Channel (page 18)
page | 11
Installation & Configuration
for more information.